WF 7 Series Thermostat / AID Tool

Discussion in 'Maintenance and Troubleshooting' started by SReg, Jul 16, 2014.

  1. SReg

    SReg New Member

    My wife and I are in the process finalizing our contract and signing the paperwork for our new Geo system.

    My question is does the thermostat that comes with this unit monitor everything like compressor current, EWT/LWT, EAT/LAT, and the hot water generator temps? Or is this something that only the Aurora (AID) tool can do?
  2. Mark Custis

    Mark Custis Not soon. Industry Professional Forum Leader

    I would ask your contractor.

  3. docjenser

    docjenser Well-Known Member Industry Professional Forum Leader

    Thermostat (the color touchscreen one) shows energy monitoring but the other things you are listing only the aid tool shows. Waterfurnace will come out with a web based monitoring system very soon, where you should be able to see the other things on your computer screen.
  4. ACES-Energy

    ACES-Energy Member Industry Professional Forum Leader

    Be sure you spent the extra $250 and get it with the Aurora Performance and Refrigeration package . I will not sell a series 5 or 7 without it..its comes standard on our contracts and I do not offer a deduct if they do not want it.
  5. docjenser

    docjenser Well-Known Member Industry Professional Forum Leader

    Dito. No unit without Aurora Performance and Refrigeration package. I also refuse to put a unit in without it.
  6. SReg

    SReg New Member

    Anyone care to elaborate on what the Performance and Refrigeration package includes?
  7. ACES-Energy

    ACES-Energy Member Industry Professional Forum Leader

    Refrigerant Monitoring
    (Standard on all 7 Series units)
    The optional Refrigerant Monitoring Kit includes two
    pressure transducers, and three temperature sensors,
    heating liquid line, suction temperature and existing cooling
    liquid line (FP1). These sensors allow the measurement of
    discharge and suction pressures, suction and liquid line
    temperatures as well as superheat and subcooling. This
    information will only be displayed on the AID Tool.
    Performance Monitoring
    (Optional sensor kit)
    The optional Performance Monitoring Kit includes three
    temperature sensors, entering and leaving water, leaving
    air temperature and a water flow rate sensor. With this kit
    heat of extraction and rejection will be calculated. This
    requires configuration using the AID Tool for selection of
    water or antifreeze.
  8. engineer

    engineer Well-Known Member Industry Professional Forum Leader

    I too have adopted ACES and Docs policy...I don't even discuss these "options" with clients.
  9. AMI Contracting

    AMI Contracting A nice Van Morrison song Industry Professional Forum Leader

    Much of this is standard on the CM digital models

Share This Page