I bought a new home that had an 18 year old Waterfurnace. Replaced it with a Climatemaster 4-ton TE-49 2 years ago. It has been 100% reliable...
You may be right, but I think my pump will actually run longer being variable speed. The reason I say this is that it only runs when the geo unit...
I replaced my 20 year old 4 ton WF Premier with a CM TE-30 4 ton unit in August. The WF was working just fine, but being 20 years old and...
[ATTACH] Decided to try a fixed setting for the modulating valve targeting a 75 LWT for the water which is a 20F Delta T. I set the first stage at...
Thanks. I'm going to have the installer look it over again to make sure all pressures and temps are in spec before proceeding, but from what I...
The interface gives you the ability to set valve % opening for both stages of heating and cooling. It just seems that may a better solution if...
Thank you for the reply. I am running a variable speed well pump set to 40 PSI and have a 30 PSI reducing valve installed on the TE30. I checked...
Just replaced my 18 Year old WF with a new TE-30 using open loop. Question about Delta T for this setup. I always thought Delta T was computed...
I thought I would reply and update. My Old 2001 WF is working well, but I have decided to put in a new Climatemaster TE30 once the remodel in...
Here is some good information on LT1 lockouts when using modulating valve on the TE30 - specifically page 47:...
Separate names with a comma.
