A single 700 foot well....standing column? Florida Heat Pump FHP is now Bosch geothermal. Is your idea now to go forced air with a desuperheater?
Oops. Sorry Mike and Blake. I misread the post.
This is not likely standing colum design as the well pump was installed two years prior to going geothermal.
The post didn't indicate standing column design. He just indicated open loop.
You may get several opinions on different solutions as there are different ways to solve the short cycling. A variable speed pumping set up would...
Caleffi has developed and described methods of constructing ground loops which don't require HDPE fusing by using pex tubing and manifolds instead.
Idronics does a great job of explaining why low temperature emitters should be chosen for geothermal hydronic installations. The low lift concepts...
I've read all nine volumes. Compared to other literature on the same topics both free and expensive, Idronics is arguably the best written of them...
"Another question is regarding the dumping of return water; thinking of heading the bleed water to the foundation perimeter drain but dont want to...
"the contractor I spoke to today promoting an open loop design advised that going with a variable speed well pump / constant pressure system would...
While you are trying to decide which way to go- Caleffi Idronics is a good free reference that might help you decide which way to go. If you...
The FHP GT036 hp was bought used and I don't know any details about it's previous instalation. The blower motor has been likely replaced because...
Blake, thanks for the reply posts. Because there was a long delay due to moderator's schedule not yours, I had the idea that you wanted to keep...
Slow down a psc (permanent split capacitor motor) from low to lower speed or swap the psc for an adjustable ECM motor? Or flow more open loop...
It's always a give and take situation situation or robbing Peter to pay Paul. I have a three speed blower which never raises up from low speed. It...
Separate names with a comma.