If the packaged unit could lay in a horizontal left configuration it might work, but I could not envision how that would work the existing duct...
I am thinking about replacing my 13 year old 13 SEER 3.5 ton R-22 single speed AC with a WF 7 split 42 or 50 in order to have better AC and...
This is what I have used for my HVAC automation at home. I actually use two of them that have their modbus registers read by a raspberry Pi using...
Can you post a picture of the pump as it is installed? Make and model number too? Pumps can be a diy replacement, it's mostly a matter of managing...
My recommendation for the Cruise is a little self serving as it would be nice to get some reports from home owners and how the install goes and...
The Hydron Cruise Variable Speed Water-to-Water unit sounds like a good fit for your application, especially of the system is not zoned in which...
I am curious about the idea of trying to run the zone pumps at the lowest speed possible. What would be the correct way to test/ensure that the...
The noise may be more than just where the unit is located. With the 5 you may have a lot more blower stops and starts and higher velocity air to...
If that system was installed today by an evolved contractor, it would definitely have variable speed pump(s) and zone valves on the load side....
A variable speed flow center would help reduce geo side pumping costs. Even more improvement could be made by replacing all your load side pumps...
Is is it possible to get the IO manual anywhere? I am interested in the Trilogy Q45 2 ton but I would like to see more detailed capacity...
The reconfigure looks like the better way make sure you get the coolest water flowing back to the desuperheater. Most will recommend a two tank...
I have been watching the WEL on the Series 7 for a few weeks now. Very informative. I hope fully modulating tech becomes standard in all geo...
Separate names with a comma.
