thank you I see on some retail sites "fusion temperature sticks" of varying degrees. I get the need to make sure the iron is at a particular...
Sometime ago, when I got interested in burying my own loop, I found used butt fusion equipment, though at the time I was not prepared to buy. The...
My heat pump is in the basement, and the loop will be run along the underside of the main floor joists over to the wall and out. Will the flush...
So only use the P/T ports off of the intake and outtake of the heat pump? Is there any benefit to having P/T ports elsewhere in the loop? like...
How do you do this? Would I install pressure gauge near the in and out lines of the heat pump?
> "you don't have to worry about pockets with socket fusion" Do you mean, that if done right there are no pockets? > "Usually a wire mesh is in...
I bought a house that has a 3 ton geothermal heat pump configured with an open loop. I want to convert it to a closed loop. I was researching and...
urthbuoy wrote: Thank you for that. After a cursory look at it, maybe the variable that is changing is the diameter of the same pipe based on...
3 ton with 3/4" piping, 7 GPM for antifreeze, though I suspect with methanol 6 GPM it would still operate effectively
urthbuoy wrote: Back when I was thinking about a series horizontal with 2" diameter pipe, by isolating the loop from the heat pump, it seemed...
The manufacturer of the heat pump that we have provides a table in their loop design guide for feet of head loss per 100 feet of various pipe and...
docjenser wrote: So the heat pump is given more time to exchange heat with the same interval of water? Ahh, so is the published heat pump flow...
Separate names with a comma.