I installed two canvas connectors, one between the air handler and and the plenum and one between the 18" supply flex and the transition to the...
Thank you! I backed off the hold down bolts and the noise from the compressor was reduced by half again. I'm now at an acceptable level; there is...
I agree and am 100% sure it is the compressor noise traveling ( and being propelled by the fan) through the ducts. the compressor was loud from...
The air handler is sitting on blocks (on the crawl space floor) with a 1" thick neoprene pad between the cabinet and the block. However; the...
Thank you, I've got that. What I wanted to know is if the amount of loop had been greater would that have significantly reduced the swings in...
My system was installed in 2010 and works great; I' very happy with it. Lat winter I started to monitor the incoming water temperature and was...
I have a "package" unit installed (horizontally) in my crawl space. While very little noise can be herd from the air handler I get a compressor...
CM27 retrofit Thank you for that insight, I won't hold my breath. When I made the decision to install GSHP I wondered if they would turn out to...
controls and retrofit OBS, You are correct, I'm out of control! I do let my recirc motor run 24-7 but it is limited by an aquastat set at 105...
demand hot water & DSH :rolleyes:Hey OBS, Everything you say is correct and I have thought it all through looking for the "best" solution. I have...
demand water heater, re-circ system & desuperheater This reply may be a little late for you but I have personal experience with this set up. I...
In April Climate Master announced the release of a new model (CM40) with on demand hot water heater. Does anyone know if they will have a...
Separate names with a comma.
