Recent Content by Lerronious

  1. Lerronious
    Post

    Balancing SCW water flow for two units

    My Orange Taco Valve is so corroded I can;t get the powerhead off. It's been in service for 9 years and is still operational so I guess I'm ahead...
    Post by: Lerronious, Oct 7, 2014 in forum: Standing Column Well (SCW)
  2. Lerronious
    Post

    Balancing SCW water flow for two units

    I can appreciate the engineering and craftsmanship that went into the job there BuffaloGeo. I've been looking over your site for quit a while....
    Post by: Lerronious, Oct 5, 2014 in forum: Standing Column Well (SCW)
  3. Lerronious
    Post

    Balancing SCW water flow for two units

    Thanks, I didn't know coil erosion was even a consideration. For clarity, they would not have flow constantly, just in tandem when either call for...
    Post by: Lerronious, Sep 25, 2014 in forum: Standing Column Well (SCW)
  4. Lerronious
    Post

    Balancing SCW water flow for two units

    I'm curious what others opinions are on two setup options. I have two W2A units, a Climate Master Genesis 1.8T and Edwards Engineering "Tetco"...
    Post by: Lerronious, Sep 25, 2014 in forum: Standing Column Well (SCW)
  5. Lerronious
    Post

    Can a natural gas fireplace insert be used as auxillary heat?

    I'm not sure if you've tackled this project yet, but you can find direct vent natural gas inserts that have a duct take off on the heat shroud....
    Post by: Lerronious, Sep 23, 2014 in forum: General Discussions
  6. Lerronious
    Post

    Balancing SCW water flow for two units

    Yes, I'm getting the same feeling. Everything is in place and relatively new so hopefully I can run it as is for a while. BTW, I was given some...
    Post by: Lerronious, May 25, 2014 in forum: Standing Column Well (SCW)
  7. Lerronious
    Post

    Balancing SCW water flow for two units

    I did some poking around and it seems there are "constant pressure" pump motor controllers that should balance the different water loads. At $1K...
    Post by: Lerronious, May 23, 2014 in forum: Standing Column Well (SCW)
  8. Lerronious
    Post

    Balancing SCW water flow for two units

    I think that is what I'm going to do, except with one valve. I'll put a flow limiter behind the 5 ton but before the discharge water recombines...
    Post by: Lerronious, May 22, 2014 in forum: Standing Column Well (SCW)
  9. Lerronious
    Post

    Balancing SCW water flow for two units

    It seems this thread is dead but I thought I'd try and give it a "bump." I have a similar situation; I have a 5 ton unit in the basement that...
    Post by: Lerronious, May 22, 2014 in forum: Standing Column Well (SCW)