Recent Content by Kenny

  1. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Cool, so perhaps I'll give it a go with my current pumps. The floors do not have antifreeze. Thanks.
    Post by: Kenny, Aug 31, 2015 in forum: General Discussions
  2. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    I suppose after all the info I've been getting on this thread, the most critical component that needs to be changed is the Geo buffer tank. Not...
    Post by: Kenny, Aug 30, 2015 in forum: General Discussions
  3. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    I always try for the best and fall back on "just working" if that fails. So I'll see if I can get a more optimized set up.
    Post by: Kenny, Aug 30, 2015 in forum: General Discussions
  4. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Thanks very much for this doc.
    Post by: Kenny, Aug 30, 2015 in forum: General Discussions
  5. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Well, it is what it is now. I have enough issues to discuss with my installer to get the rest of the system working right. The whole Geo thing in...
    Post by: Kenny, Aug 29, 2015 in forum: General Discussions
  6. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    My installer chose the flow center. He has worked with them before and said they're really nice since the are non pressurized and purge...
    Post by: Kenny, Aug 29, 2015 in forum: General Discussions
  7. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    I am very interested in seeing a diagram of how direct flow to the loops can be achieved (I'll PM you), but my question about that is, if the HP...
    Post by: Kenny, Aug 28, 2015 in forum: General Discussions
  8. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Thanks Geoxne. I'm sure the ECO-0550 would be cheaper so I'll see if I can get my installer to take a look and perhaps get on board with that....
    Post by: Kenny, Aug 28, 2015 in forum: General Discussions
  9. Kenny
    Post

    Wisconsin My DIY GEO Install

    As I posted in another thread, I'm using the Crete-Heat panels. Thicker ones for the basement and thinner for main and upper floors. Since mine...
    Post by: Kenny, Aug 28, 2015 in forum: Geothermal Heat Pump Testimonials
  10. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    The issue of Aux heat wasn't fully planned so that's why I started this thread.
    Post by: Kenny, Aug 28, 2015 in forum: General Discussions
  11. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Yes. Bore holes grouted with SuperGrout.
    Post by: Kenny, Aug 28, 2015 in forum: General Discussions
  12. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    As I said I don't know the run length but I do know that the picture (yellow crete-heat panels) is 865sqft and has 4 loops. Living room is smaller...
    Post by: Kenny, Aug 28, 2015 in forum: General Discussions
  13. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Doc, All floors are done and covered with thermafloor/gypcrete. In fact I'm hoping to move into the house in a couple weeks. I do not know length...
    Post by: Kenny, Aug 27, 2015 in forum: General Discussions
  14. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    I really appreciate all the input here, really gives me more perspective on the design considerations. I really did try to do my homework before...
    Post by: Kenny, Aug 27, 2015 in forum: General Discussions
  15. Kenny
    Post

    Auxilary Heat on Water to Water GSHP

    Andy, No I don't have an outdoor reset control but installation isn't done yet and could still get such a thing put in. My concern with single set...
    Post by: Kenny, Aug 27, 2015 in forum: General Discussions