One thing no one seems to mention in 'lockouts' is -a DIRTY AIR FILTER / LOW AIR FLOW will cause lockouts, both HIGH and LOW-.
Pulling the pump was in fact 'easy peasy'. I normally charge headlong into taking things apart, figuring if someone else can do it I can too. I...
I drained QT Flow Center and removed both motors. The lower one had two pieces of rusty metal in the impeller. It was also 'sticky' when I spun...
I REALLY APPRECIATE your QUICK response !!! Thank you !! (It's getting cold here in MO) I figured the UP26-99F might work but was concerned about...
I've been here for a number of years reading. But thanks for the welcome. It's good to get a response. According to the Econar LOCKOUT...
I have a -NON PRESSURIZED- QT Flow Center Model:2 2300 FC-HG that needs motors replaced. What is the correct way to replace them ???? Where can I...
Any recommendations on how to REPLACE a pump motor ?? Do I need to drain everything or just the FLOW CENTER ?
ECONAR GV590-1-T000: Since this was installed in 2003 the GSHP has -occasionally- tripped the FAULT indicator on the thermostat, but when I open...
GSHP is an Econar 15 years old, thermostat is the same. Voltages appeared correct, I checked them over and over and over at the thermostat and the...
Correct. Fan comes on but not compressor. No lockout, no fault light on control board. Compressor should come on about 2 seconds after fan....
GeoSource 2000- Compressor WN start in HEAT MODE, RUNS in COOL MODE. NO lockouts indicated. 24v is at the control board for HEAT and fan control....
Separate names with a comma.