Yes, this stage 2 running continuously has been my headache for a while. While I am about to monitor loop temps, here are my controller settings....
Dear all, since I am on this post already, I ordered P and T gauges for my external loop. However, one thing bothers me in the current setup. Once...
Very useful. I am actually trying to find tridicator gauges and connect them to PT port via valve. Now if only there were lower T tridicator...
Stupid question: is it possible to measure both? PT2 and PT1 are ports on the downstairs unit for the external loop?
I was just wondering (if the post is still active) how to measure the delta T between the ground loop in my Geothermal unit. I am afraid that once...
Funny story. Turns out while I was travelling my donwstairs unit tripped on low temperature reading. Turns out that external loop lost the...
Thank you, Stickman. There is an option to momentarily display that on instrument display. I could not find any option on Lyric to display or...
OK, thank you all. Looks like there is no reason to implement this monitoring on the furnace. My controller is T5 from Honeywell. I could not find...
OK, newest development happened when the fan circulated all night with aux heater on and I went to the basement and the unit was off! Installer...
thank you. One question: if I install Symphony will that provide the measured values for me? Also, could you elaborate re ducts since the...
Thank you. I have been running this unit for a couple of months now and I must say I am running it blind. Yesterday it was trying to maintain 66...
thank you
Thank you. I must say I am puzzled about Symphony and all the dealer/contractor thing. My contractor showed me the port to connect to diagnose the...
Dear all, I have a 3 ton unit installed 2 weeks ago with vertical 450 feet and split unit waterfurnace 500r11. That one is really a pain since it...
Separate names with a comma.