Recent Content by Ichthyoman

  1. Ichthyoman
    Thread

    What to do with your old Waterfurnace?

    So, I have a 20 year old Waterfurnace that is getting replaced. I was wondering what to do with the old unit? Is it worth anything? It looks in...
    Thread by: Ichthyoman, Jan 27, 2014, 5 replies, in forum: General Discussions
  2. Ichthyoman
    Thread

    Replace compressor or entire unit--what's best for a 20-yr old Waterfurnace?

    Hi all I have circa 1994 Waterfurnace, model # ATV045D110CRT, that is showing signs of trouble. Recently, we had some very cold temps here in...
    Thread by: Ichthyoman, Dec 13, 2013, 2 replies, in forum: Maintenance and Troubleshooting
  3. Ichthyoman
    Thread

    A cure for noisy Taco solenoid valves?

    Hi all I recently installed an new discharge water manifold on my Water Furnace (thanks to all who gave advice!). I installed a couple of Taco...
    Thread by: Ichthyoman, Apr 25, 2013, 2 replies, in forum: Maintenance and Troubleshooting
  4. Ichthyoman
    Post

    How to properly set up an exit water discharge system?

    Thanks all, appreciate the info. Should be tackling this project soon. Also stumbled upon a company called Flow Center Products, in Indiana, I...
    Post by: Ichthyoman, Mar 8, 2013 in forum: Open Loop
  5. Ichthyoman
    Post

    How to properly set up an exit water discharge system?

    Hi Chris et al. Well, I'm finally getting around to implementing Chris's suggestions for my Water Furnace discharge manifold. And, as you might...
    Post by: Ichthyoman, Mar 7, 2013 in forum: Open Loop
  6. Ichthyoman
    Post

    How to properly set up an exit water discharge system?

    I see. How do you keep both solenoids open at the same time? I have four wires coming from my furnace, two for one valve, two for another. How...
    Post by: Ichthyoman, Jan 19, 2013 in forum: Open Loop
  7. Ichthyoman
    Post

    How to properly set up an exit water discharge system?

    Hi Chris Thanks for the reply. A couple of questions. I did purchase a couple of Taco 5101-G2 valves. Felt I had to, just have too much water...
    Post by: Ichthyoman, Jan 19, 2013 in forum: Open Loop
  8. Ichthyoman
    Thread

    How to properly set up an exit water discharge system?

    Hi all I'm new to the forum and hope I can get some good advice for questions I have about properly setting up an exit water discharge manifold...
    Thread by: Ichthyoman, Jan 17, 2013, 10 replies, in forum: Open Loop