what about phase change btu's? Didn't the water change states between 25 degrees and 50 degrees? Wouldn't the btu's required between 50 and 25...
estimated r-value of poured concrete tank? I'd place the r-value of a pre-cast concrete tank around 0.1 per inch. But I'm no engineer. I don't...
I wouldn't recommend it We have an ICF house with very low cooling needs plus very low air infiltration. So we are able to dehumidify below dew...
how did this system end up working? How did this project turn out? I'd like to use a water to water geo to chill our processing plant. Against...
heat of the compressor motor The motor is going to add some heat in heating mode and its going to distract from the cooling mode.
I've never seen a loop in person I've never seen a loop in person but I hear talk of people putting in 250 feet of slinky per ton of geo. I...
bedrock was their issue Didn't he say bedrock was a problem at their site? I would think that could make it difficult for a horizontal or a...
sorry, I just joined the forum I'm a new member. Its not an old thread to me. They are all new. We have a water to water geo in Northeast,...
how deep is your tank going to be? How deep will your tank be? How many feet of loop between the geo and before you get to the tank? Assuming...
I like the idea of a pressure switch We put a thermostat on our geo in addition to the geo's internal safeguards. I'm a huge fan of Ranco's...
Separate names with a comma.
