Jim, Are your pumps on the 2nd floor? If so, as Eric pointed out - have you considered pump cavitation rather than corrosion as the cause of the...
I do not believe that anyone sells just the module. There is software (programming) involed for the motor to work right on your CM unit.
Thank you Eric! I will leave it alone. I will plan on going to non pressurized when it needs to be replaced.
I am asking for some advice from the drillers and others with flush carts on this forum. Here is my problem: 8 year old single pump (26-99)...
Further update: reducing CPH from 3 to 2 did not seem to make any difference at all. When I went down to 1 CPH, things got better. I now have both...
Update: staying on stage 1 much longer so less cycles off. But when it does cycle off the same issue still happens. I'm going to also try reducing...
I think the main cause of the 5 minute off is that the heat load of the house is now around 95-100% of the stage 1 capacity. I've measured my...
The problem seems to be that because the thermostat doesn't know that the cxm board is keeping the compressor off, it is expecting to see some...
I contacted Climatemaster today to see if I could get this explained. Here is the story: The new cxm board has a guaranteed 7 min. of compressor...
So I ordered a new cxm board and installed it yesterday. The new board looked identical to the old but I noticed the part number on the new board...
I woke up early this morning to the smell of the aux. heat strips running full blast. Thermostat showed house at 3 degrees below set point and aux...
Thanks Eric! I've soaked the ground pretty thoroughly with a water/ground-up hot pepper solution (had a good crop of peppers from the garden this...
Maybe an off-beat type of question for loopers and drillers: anyone ever have any trouble with moles chewing up PE piping? I have some mole signs...
Separate names with a comma.
