- Friday, 30 October 2009 13:40
GeoExchange technology uses the earth's renewable energy, just below the surface, to heat or cool a home or other building, and to help provide domestic hot water. It's sometimes referred to as a geothermal heat pump, a ground source heat pump, or earth energy. No matter what you call it, GeoExchange systems are the best choice you can make for both your pocketbook and your planet. In fact, these systems are so good that the U.S. Environmental Protection Agency (EPA) has said they are, "the most energy-efficient, environmentally clean, and cost-effective space conditioning systems available today".
- Friday, 30 October 2009 13:53
A few feet beneath the surface, the earth's temperature remains fairly constant year-round, ranging from 45º or so in northern latitudes to about 70ºF in the deep south. GeoExchange takes advantage of this constant temperature to provide extremely efficient heating and cooling.
In winter, a fluid circulating through pipes buried in the ground absorbs heat from the earth and carries it into the home. The GeoExchange system inside the home uses a heat pump to concentrate the earth's thermal energy and then to transfer it to the interior space for warmth.
In the summer, the process is reversed: heat is extracted from the air in the house and transferred through the heat pump to the ground loop piping. The fluid in the ground loop then carries the heat back to the earth. The only external energy needed for GeoExchange is the small amount of electricity needed to operate the heat pump, ground loop pump and distribution fan or pump.
- Friday, 30 October 2009 14:04
The basic technology has been around for more than 50 years, and many homeowners and businesses have been enjoying the benefits of GeoExchange for much of that time.
In recent years, though, significant improvements have been made in the materials used, installation methods, electronic control systems, and the efficiencies of the compressors, pumps and other equipment.
- Friday, 30 October 2009 14:41
Owners enjoy lower utility bills (25% to 70% lower than with conventional systems), lower maintenance, and higher levels of comfort, year-round. They also have the peace of mind of knowing they're being environmentally responsible.
Since a GeoExchange system burns no fossil fuel on-site to produce heat, it generates far fewer greenhouse gas emissions than a conventional furnace, and completely eliminates a potential source of poisonous carbon monoxide within the home or building. Even factoring in its share of the emissions from the power plant that produces electricity to operate the GeoExchange system, total emissions are far lower than for conventional systems.
- Friday, 30 October 2009 14:43
According to data supplied by the U.S. Department of Energy (DOE) Office of Geothermal Technologies, nearly 40% of all U.S. emissions of carbon dioxide (CO2) are the result of using energy to heat, cool and provide hot water for buildings. This is about the same amount of CO2 contributed by the transportation sector.
A typical 3-ton residential GeoExchange system produces an average of about one pound less Carbon Dioxide (CO2) per hour of use than a conventional system. To put that in perspective, over an average 20-year lifespan, 100,000 units of nominally sized residential GeoExchange systems will reduce greenhouse gas emissions by almost 1.1 million metric tons of carbon equivalents.
That would be the equivalent of converting about 58,700 cars to zero-emission vehicles, or planting more than 120,000 acres of trees.And the waste heat removed from the home's interior during the cooling season can be used to provide virtually free hot water-resulting in a total savings in hot water costs of about 30% annually, and lowering emissions even further.
- Friday, 30 October 2009 14:44
There are more than one million installations in the United States today. Although this is a very small percentage of the total HVAC market, the number of people who are choosing to install GeoExchange is growing rapidly as more learn about the technology.
- Friday, 30 October 2009 14:45
While many homes have been fitted with GeoExchange systems, a large number of commercial enterprises, including factories, retail stores, office buildings and schools also use GeoExchange to save energy and protect the environment. In fact, there are more than one million installations in the United States today.
According to the U.S. Environmental Protection Agency (EPA), schools are a particularly attractive place for the use of technology. Across the country, schools using GeoExchange right now are saving an estimated $25,000,000 in energy costs-which can be used instead for better educational equipment and more teachers. These schools also save a half-billion pounds of Carbon Dioxide (CO2) emissions per year.
Should all of the nation's schools convert to GeoExchange, the EPA has estimated that we could reduce oil imports by 61 million barrels annually, and provide the same environmental benefits as planting 8 million acres of trees or converting nearly 4 million cars to zero-emission vehicles.If the same comparison were made across all commercial and residential segments, the potential for environmental benefit would be staggering.
- Friday, 30 October 2009 14:47
Yes, GeoExchange technology can be used in any part of the country. Why? Because it transfers heat to and from the earth, which remains at a relatively constant temperature, rather than the air, where temperatures can vary greatly.
- Friday, 30 October 2009 14:49
Not necessarily. It depends on how you measure cost. While they sometimes cost more to install in homes than conventional systems because of the ground loop piping, GeoExchange systems typically have the lowest life-cycle cost of any heating and cooling system. Heating and cooling costs for a typical 2,000-sq.-ft. home can run as low as $1 a day.
Moreover, installation costs have declined substantially in recent years, and they're expected to continue to fall, as more builders and contractors offer GeoExchange systems, and as the industry develops innovative ways to install the systems faster and more efficiently.
Altogether, GeoExchange systems are a sound investment. The amount they save the homeowner every month in energy costs is more than enough to offset their higher installation cost.
Remember, too, that GeoExchange means extra savings on repair, maintenance, and hot water bills.
Furthermore, the energy efficiency of the system adds value to the home. The National Association of Realtors Appraisal Journal estimated that a home's value increases by $10 to $25 for every $1 reduction in utility bills. That's a lot of equity to build just by choosing GeoExchange!
- Friday, 30 October 2009 14:50
The prices have a wide range based on a number of variables, such as your home or building's size and design, the brand and model you choose, your location, etc., so it is difficult to estimate without considering those specific factors.
To find out how much it would cost to add a GeoExchange system into your home or business, you will need to contact a contractor in your area for an estimate. We can help you locate one by calling us toll-free at 1.888.All.4Geo.
- Friday, 30 October 2009 14:52
- Friday, 30 October 2009 14:53
While we don't offer financing, we suggest you contact your mortgage broker or local bank to see about using a home equity loan or some other sort of conventional financing means. You might also want to ask your contractor if he/she is able to offer funding through their company or through the manufacturer.
Another option you might consider is obtaining an Energy Efficient Mortgage (EEM) through another lender - click here to read more about EEMs on the ENERGY STAR website.
- Friday, 30 October 2009 14:55
Some states and utilities have programs to encourage you to install GeoExchange. For a comprehensive listing of incentives for renewable energy systems, go to the Database of State Incentives for Renewables and Efficiency. You might also consider calling your state energy office or local utility for more information.
- Friday, 30 October 2009 14:56
The size of the system depends on the size and design of your home or building. Just as with the previous question about cost estimation, sizing questions are best answered by a local contractor who can take into context all the variables of your unique installation. Call us toll-free at 1.888.All.4Geo for more information.
- Friday, 30 October 2009 14:58
Proper design and installation of GeoExchange systems is facilitated by specialized training provided by manufacturers and industry leaders. Call us toll-free at 1.888.All.4Geo for more information.
I just bought a home/building with a GeoExchange system. Who should I call to make sure it's operating properly?
- Friday, 30 October 2009 15:01
- Friday, 30 October 2009 15:03
- Friday, 30 October 2009 15:05
First, allow us to congratulate you on considering joining one of the fastest growing HVAC markets in the United States! A great place to start is by joining GEO - our members are always "in the know" with our regular member updates and have found their partnership with GEO to be very beneficial to their business. Click here to learn more about becoming a GEO Member.
As you can see, we highly recommend using an accredited professional. If you are interested in becoming an accredited installer yourself, our sister organization IGSHPA delivers all our training courses. You can visit them on the web here.